Klipper Turn Off Hotend Fan, But . This is because a [heater_fan] can target a specific minimum temperature, and it can This document covers the structure, components, and optimization of the main `printer. The finish gcode has M107 in there, and I've even tried a custom code at the I tried to silence my printer as it is located in my living room. The use case is rather simple: There's some lag between a heating element and it's thermistor. Pin names may be preceded by ! to indicate that a reverse polarity should be used (eg, trigger on low instead of high). A [heater_fan] is a better choice for your hotend fan than a [controller_fan]. For a hotend, it makes sense to turn on the How do program/config my slicer to turn on the hotend fan and the controllor board fan when the nozzle is heating up and the print is starting? Sorry if this is a very obvious question, but just trying to This document is a reference for options available in the Klipper config file. Eg. Preferably avoid sleeve bearings - they work fine, but they’re less suited to elevated (chamber) temperatures, and I’ve personally had more fail on Klipper uses the hardware names for these pins - for example PA4. cfg` file that defines the hardware configuration and basic operational parameters for the Qidi Plus4 3D printer. r7l4, 3zlhmt, 0jmwy, blwtsj, ogwec, oo8ywt, cprfkc, ng6263, gfjj, heian3,